Burkert Flowave 8098, Operating Instructions Manual

Page: 168 / 354

168
SAW sensor – Parameter
Type 8098 FLOWave L
By default, the monitoring of the mass flow rate is disabled, and the diagnostics are all disabled.
To activate the monitoring of the mass flow rate, do the following:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values Mass flow
→
Limits
→
Active
→
Yes
.
→
Save.
The monitoring of the mass flow rate is active and the device status will change depending on the limits
that have been set.
→
You can configure the behaviour of an analogue output depending on the status of the device. See
chapter 18.3.3 .
→
You can configure a digital output to switch every time a specific event is generated. See chapter 18.5.1
Configuring a digital output as an on/off output .
→
To enable the monitoring, i.e. to be informed when the value of the mass flow rate is outside the normal
range, enable the diagnostics. See chapter 12.10 Activating the diagnostics function .
15.5.6 Deactivating the monitoring of the mass flow rate
By default, the mass flow rate values are not monitored.
But if the monitoring of the mass flow rate is active, do the following to deactivate it:
→
Go to the CONFIGURATION view.
→
SAW sensor
→
Confirm to access the Parameter view.
→
Stand. meas. values Mass flow
→
Limits
→
Active
→
No .
→
Save.
The monitoring of the mass flow rate is inactive.
English