Burkert Flowave 8098, Operating Instructions Manual

Page: 63 / 354

63
Electrical installation
Type 8098 FLOWave L
8.11 Wiring the device through the M20x1.5 cable glands in
nickel plated brass (device variant with cable glands)
Put only one cable in each cable gland.
→
Prepare cables that obey the specifications given
in chapter 8.6 and chapter 8.7 .
→
To open the front of the transmitter, follow the
instructions given in chapter 8.9.
1. Use a size 10 hexagonal key to loosen the 2
screws of the functional earth plate.
2 screws
2. Strip 100 mm of the cable.
3. Reduce the shield to 20 mm.
4. Expose 8 mm of the conductors.
20 mm
100 mm ±5
8 mm
5. Loosen the nut of the cable gland.
6. Remove the blind plug of the cable gland and
store the blind plug in a safe and clean place.
7. If the cable diameter is between 5 and 9 mm, put
the cable through the cable gland as shown in
the figure.
8. Use a size 24 hexagonal key to tighten the cable
gland to a torque of 10 Nm (7.4 ft·lbf).
9. If the cable diameter is between 9 and 14 mm,
→
vertically put a screwdriver between the two
seals,
→
lift the inner seal and remove it.
→
Put the cable through the cable gland.
→
Use a size 24 hexagonal key to tighten the cable
gland to a torque of 10 Nm (7.4 ft·lbf).
English