Burkert Flowave 8098, Operating Instructions Manual

Page: 297 / 354

297
Outputs – Parameter
Type 8098 FLOWave L
To configure a digital output as a pulse output, do the following:
→
Go to the
CONFIGURATION
view.
→
Outputs
→
Confirm to access the Parameter view.
→
Output 2:digital or Output 3:digital
→
Mode
→
Pulse
→
Settings
The
Current settings
are displayed
→
Enabled
→
Set the value of the maximum duration of a pulse
→
Set the value of the maximum frequency for the transmission of the pulses
→
Choose pulse/volume or volume/pulse in the wanted volume units
or
→
Choose
pulse/mass
or
mass/pulse
in the wanted mass units
→
If you have chosen
pulse/volume
, set the number of pulses to be transmitted on the digital
output for either 1 litre or 1 US gallon or 1 imperial gallon. Enter a number of pulses that is higher than 1.
If you enter a number of pulses that is lower than 1, the display resolution is not optimum.
→
If you have chosen volume/pulse , set the volume of liquid for which 1 pulse is transmitted on
the digital output
→
If you have chosen
pulse/mass
, set the number of pulses to be transmitted on the digital output
for either 1 g, 1 kg, 1 lb or 1 t. Enter a number of pulses that is higher than 1. If you enter a number of
pulses that is lower than 1, the display resolution is not optimum.
→
If you have chosen mass/pulse , set the mass of liquid for which 1 pulse is transmitted on the
digital output
→
Choose to invert the signal or not
→
Choose the counting direction The New settings are displayed.
→
Save.
The digital output is configured as a pulse output.
English