Burkert Flowave 8098, Operating Instructions Manual

Page: 56 / 354

56
Electrical installation
Type 8098 FLOWave L
→
To connect the device, remove the screwed plug of the 5-pin M12 male connector and store the
screwed plug in a safe and clean place.
Risk of damage to the device if an M12 connector is unused.
▶
Put a screwed plug on all the unused M12 connectors.
Malfunction of the internal and external communication if the 5-pin M12 male connector is not used
to connect the device to a büS fieldbus or a CANopen fieldbus.
▶
Make sure pin 4 (CAN_H) and pin 5 (CAN_L) are both contact free if the 5-pin M12 male connector
is not connected to a büS fieldbus or a CANopen fieldbus.
→
If the device is connected to a büS network or to a CANopen network and installed at one end of the
büS network or of the CANopen network, either install one or two 120
W
termination resistors in the line
or activate the device internal termination resistor: see chapter 8.5 . The büS or CANopen line must be
adapted to reached 60
W.
If a device with two 4-pin M12 female connectors (Ethernet device variant) is connected to an Eth -
ernet network, you must connect it to a büS / CANopen network for the configuration of the device
with the software Bürkert Communicator.
1
2
3
4
5
• Pin 1: CAN shield
• Pin 2: 12...35 V DC
• Pin 3: GND
• Pin 4: CAN_H
• Pin 5: CAN_L
Fig. 22: Pin assignment of the 5-pin M12 male connector
Cable and conductors
connected inside the
device to the 5-pin M12
male connector
Fig. 23: Wiring ex works of the 12 push-in terminal strip to the 5-pin M12 male connector
English