Burkert Flowave 8098, Operating Instructions Manual

Page: 114 / 354

114
General settings – Parameter
Type 8098 FLOWave L
→
General settings
→
Confirm to access the
Parameter
view.
→
büS Advanced
→
büS address
→
Change the address of the device. Make sure you enter an address that is not already used on
the same CANopen fieldbus.
→
Save.
The address of the device is changed.
→
Start the device to take the new address into account. See chapter 14.3.1 Restarting the device .
12.6.6 Setting the digital communication for büS or for a CANopen
bus
By default, the operating mode of the digital communication is set to Standalone and the measured
process data (PDOs, process data objects) is not sent on a connected fieldbus.
The other operating modes of the digital communication are büS or CANopen .
If the device is connected to büS or to a CANopen bus, do the following to change the operating mode of
the digital communication:
→
Go to the CONFIGURATION view.
→
General settings
→
Confirm to access the Parameter view.
→
büS
→
Advanced
→
Bus mode
→
büS or CANopen .
→
Save.
→
Restart the device.
The operating mode of the digital communication is büS or CANopen.
If the operating mode of the digital communication is büS, the CANopen status is set to Operational
(see chapter 13.3.6 ) and the PDOs are sent to büS.
If the operating mode of the digital communication is CANopen, the
CANopen status
is set to
Pre-op
(see chapter 13.3.6 ) until the CANopen network master switches the device to
Operational
.
→
To stop the PDOs being sent to büS or to a fieldbus, see chapter 12.6.7 .
English