Error messages and troubleshooting
Parameter manual
b maXX
BM5800
Document No.: 5.16029.03
747
4
1100
Drive manager general error pulse
enable
When a pulse block has no reason that can be recognized by the
drive manager (AM) (recognizable are: digital input, error with
response pulse block, command control word), there is a threat of an
endless change of statuses in the AM:
Statuses 2->3->2 etc. are continuously processed because all
switching conditions are met and the AM continues to attempt to
activate the drive.
To prevent this, the change in status 3 will be disabled when a pulse
block is recognized, a marker will be set and the error RC_ERR_D-
MGR_IF is entered for signaling.
No change is possible in Status 3 as long as the marker is set.
m
Effect:
The drive switches to Status 15 (Error). Other responses are no
longer permitted so that the drive cannot automatically restart in
the case above (pulse block without entering a error with pulse
block) after Error #1100 has been reset.
Pulse block
1101
Motor parking brake does not open
when the drive ist started
The motor parking brake should open in Automatic mode of the
brake activation when the drive is activated but it does not.
m
Effect:
The drive is not activated so that it does not try to drive against the
closed brake. The above error message will be issued. The error
bit will be activated in the status of the brake activation.
Pulse block
1102
Motor parking brake does not close
when the drive is switched off
The motor parking brake should close in Automatic mode of the
brake activation when switching off after active braking (pulses are
activated, should be switched off), but it does not.
m
Effect:
The above error message is issued. The error bit will be activated
in the status of the brake activation. The response of the drive
depends on the error response that has been set:
n
Pulse block:
The drive blocks the pulses and will be switched off.
n
otherwise:
At first, the pulses remain switched on. The drive can then
either be switched off depending on the status in the drive man-
ager through a corresponding command (->Blocking of pulses)
or reactivated.
No response
1103
Cyclical monitoring of brake activation
reports error
The cyclical monitoring of the brake activation determines that the
set value and actual status of the motor parking brake do not match
(brake should open but is closed or brake should close and is
opened).
m
Effect:
The above error message is issued. The error bit will be activated
in the status of the brake activation. The response of the drive
depends on the error response that has been set.
No response
1104
Motor parking brake: Brake moment
prior to opening the brake not reached
The drive should build up in the Automatic mode of the brake activa-
tion during enable before opening the motor parking brake but can-
not reach a stop moment.
m
Effect:
The drive is not activated to prevent a possibly hanging load from
dropping. The above error message will be issued. The error bit
will be activated in the status of the brake activation.
Pulse block
1105
Cyclical monitoring of the brake pad
reports the error
The cyclical monitoring of the brake pad detects a error.
m
Effect:
The above error message is issued. The error bit will be activated
in the status of the brake activation. The response of the drive
depends on the error response that has been set.
No response
Error
num-
ber
Brief error text
Error description
Default set-
ting for
Error
Response
