Baumuller b maXX BM5800, Parameter Manual

Page: 19 / 816

Commissioning
Parameter manual b maXX BM5800
Document No.: 5.16029.03
19
of 814
2
2 Make sure that the installation is carried out correctly and, in particular, that all safety
regulations have been observed (see Installation in the Operating Manual for the
b maXX

5000 basic unit).
3 ProDrive must be installed on the PC/Laptop.
During commissioning you can, among other things, enter motor and encoder data in the
operating software or correct incorrect values. So that you can perform the commission-
ing efficiently, it is advantageous to have all the data at hand for the commissioning. Data
for Baumüller motors are available in the form of a "Motor Database" within the operating
software.
4 Make sure that all the necessary data are at hand.
Motor data

(Identification
plate)
These data can be found, e.g., on the identification plate for the motor that you are using
for the commissioning.
The motor database is used in this example; the values in the table are provided only for
checking purposes.
Motor data

(Data sheet)
These data can be found on the data sheet for the motor that you are using for the com-
missioning.
1)
You can also have ProDrive determine the notch angle (see
Z
Searching for the notch position
–
on page 40).
Encoder data

(Data sheet)
These data can be found on the data sheet for the encoder that you are using for the com-
missioning.
Name Value, e.g. Used for entering in the parameter list /parame-
ter
Motor type, designation DS 56-M Parameter list/Motor configuration
Z
107.2
–
Motor type
Nominal voltage U
N
330 V Parameter list/Motor configuration
Z
107.8
–
Nominal voltage
Nominal current I
N
4.0 A Parameter list/Motor configuration
Z
107.9
–
Nominal current
Nominal speed n
N
3000 rpm Parameter list/Motor configuration
Z
107.7
–
Nominal speed
Name Value, e.g. Used for entering in the parameter list /parame-
ter
Max. current I
mot,max
14.3 A Parameter list/Motor configuration
Z
107.21
–
Maximum drive current
Number of pole pairs 3 Parameter list/Motor configuration
Z
107.19
–
Pole pairs
Max. speed n
max.
6000 Parameter list/Motor configuration
Z
107.26
–
Maximum speed mechanical
Notch angle, if specified
1)
240° Parameter list/Motor configuration
Z
127.8
–
Encoder Offset el.
Name Value, e.g. Used for entering in the parameter list /parame-
ter
Encoder type Stegmann SRS
50/60 SinCos
encoder With sine-cosine encoders with HIPERFACE

inter-
face, the encoder type is read in automatically via
the HIPERFACE

interface
Number of pulses 1024 Parameter list/Encoder configuration/

Z
137.1
–
Number of pulses