LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
540
User Manual 1173.9628.02 ─ 16
In the Standalone (SA) scenario, this parameter is controlled by the measurement. In
the Combined Signal Path (CSP) scenario, it is controlled by the signaling application.
Remote command:
(SA)
(CSP)
Scenario = StandAlone
The multi evaluation measurement is used standalone.
Remote command:
Scenario = Combined Signal Path
Allows to use an LTE signaling application (option R&S CMW-KS500/-KS550) in paral-
lel to the LTE multi evaluation measurement. The signaling application is selected by
the additional parameter "Controlled by".
Most parameters described in this section and some parameters described in section
display values determined by the signaling application.
The corresponding measurement settings are remembered in the background and dis-
played again when switching back to the standalone scenario.
Connection status information of the signaling application is displayed at the bottom of
the measurement views. Softkeys and hotkeys provide access to the settings of the
signaling application and allow to switch the downlink signal on or off, see
ter 3.3.8, "Additional Softkeys and Hotkeys"
For additional information see
chapter 3.2.1.5, "Parallel Signaling and Measurement"
Remote command:
Scenario = Measure@ProtocolTest
Allows to use an LTE protocol test application in parallel to the LTE multi evaluation
measurement. The protocol test application is selected by the additional parameter
"Controlled by".
The signal routing and analyzer settings described in this section are ignored by the
measurement application. The corresponding settings have to be configured within the
protocol test application.
Protocol test applications are available for R&S CMW500, but not for R&S CMW270
and R&S CMW280.
Remote command:
GUI Reference
深圳德标仪器
135-1095-0799