LTE Signaling
R&S
®
CMW-KM5xx/-KS5xx
123
User Manual 1173.9628.02 ─ 16
Configure the input PEP so that it matches the baseband output of the connected
instrument.
Remote command:
Crest Factor (Out)
Indicates the crest factor of the baseband signal, i.e. the ratio of peak to average base-
band power. The average power is calculated for time intervals with active downlink
traffic channel timeslots only.
Use the displayed crest factor value to configure the baseband input of the connected
instrument.
Remote command:
Baseband Level (In)
Indicates the nominal RMS level of the baseband signal during a call (connection
established).
Configure the baseband level so that it matches the baseband output of the connected
instrument.
Remote command:
2.4.6 RF Settings
The parameters in this section configure the RF input and output paths.
Fig. 2-48: RF settings (1 Cell - 1 RF Out)
For descriptions of the parameters, refer to the subsections.
.................................................................................................124
.........................................................................................129
GUI Reference
135-1095-0799