5-48
CHAS
HANDLEBAR
13. Install:
9
“ENGINE STOP” button
1
9
Clutch lever holder
2
9
Bolt (clutch lever holder)
3
9
Clamp
4
NOTE:
9
The “ENGINE STOP” button, clutch lever hold-
er and clamp should be installed according to
the dimensions shown.
9
Pass the “ENGINE STOP” button lead in the
middle of the clutch holder.
4 Nm (0.4 m•kg, 2.9 ft•lb)
12. Install:
9
Bolt (grip cap)
1
w
9
Install the grip cap so that the gaps
a
a
and
b
b
between the bolt (grip cap) and brake
lever
2
2
are equal. If you make a mistake in
the grip cap installation position, the brake
lever may contact the grip cap, resulting in
poor brake performance.
9
After tightening the bolts, check that the
throttle grip
3
3
moves smoothly. If it does
not, retighten the bolts for adjustment.
4 Nm (0.4 m•kg, 2.9 ft•lb)
11. Install:
9
Master cylinder
1
9
Master cylinder bracket
2
9
Bolt (master cylinder bracket)
3
NOTE:
9
Install the bracket so that the arrow mark
a
faces upward.
9
First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the bolt
on the lower side.
9 Nm (0.9 m•kg, 6.5 ft•lb)
1P8-9-32-5c 4/10/06 4:42 PM Page 14
Summary of Contents for YZ250(W)/W1
Page 78: ...2 11 MAINTENANCE SPECIFICATIONS SPEC MEMO...
Page 594: ...TUN MEMO...