Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 192 / 434

E6581611
F-12
6
6.2 Selection of operation mode
6.2.1 Selection of start/stop and frequency settings


: Command mode selection
 : Frequency setting mode selection

Function
These parameters are used to specify which input device (panel keypad, terminal block, or
communication) takes priority in entering an operation stop command or frequency setting mode (terminal
VIA/VIB/VIC, setting dial, communication, or UP/DOWN from external logic).
<Command mode selection>
[Parameter setting]
Title Function Adjustment range Default setting

Command mode selection
0: Terminal block
1: Panel keypad (including extension panel)
2: RS485 communication
3: CANopen communication
4: Communication option
1
[Programmed value]

:
Terminal block
operation
ON and OFF of an external signal run and stop operation.
 :
Panel keypad
operation
Press the and keys on the panel keypad to run and stop.
Operation can also be done from the extension panel.

:
RS485
communication Run/stop operations by RS485 communication from an external device.
⇒
Refer to section 6.33.
3 :
CANopen
communication Run/stop operations by CANopen communication from an external device.
⇒ Refer to “CANopen communication Instruction Manual E6581911”.
4
:
Communication
option Run/stop operations by commands from a communication option.
⇒ Refer to each Instruction Manual of option.
* Operation command selected by
 and the operation commands from the terminal block can be
switched alternately with ON/ OFF of input terminal. (input terminal function number 108, 109) See the table of
input terminal function selection in section 11.6.
* When priority is given to commands from a linked computer or terminal block, they have priority over the
setting of  .
STOP
RUN