Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 299 / 434

E6581611
F-119
6
6.32 Analog input terminal function selection
f214
: VIB input point 1 rate
f215 : VIB input point 2 rate
f663
: Analog input terminal function selection (VIB)
•
Function
Parameter is normally set from operation panel. However some parameters can be continuously set from
external analog input by using this function. VIB terminal is used.
[Parameter setting]
Title Function Adjustment range Default setting
f214 
VIB input point 1 rate -250-+250 (%) 0
f215  VIB input point 2 rate -250-+250 (%) 100
f663 
Analog input terminal function
selection
(VIB)
0: Frequency command
1: Acceleration/deceleration time
2: Upper limit frequency
3, 4: -
5: Torque boost value
6: Stall prevention level
7: Motor electronic-thermal protection level
8 to 10: -
11: Base frequency
0
+
Analog input terminal function assigns VIB terminal. The range of analog input voltage is 0% to +100%.
From -100% to 0% cannot be used.
+
The parameter that is selected by f663 can be adjusted range as following table.
Setting of f663 Object parameter VIB : 0% input VIB : 100% input
0: Frequency
command
- - -
1: Acceleration/
deceleration time
acc
,
dec
,
f500
,
f501 , f510 , f511
Parameter setting value x
f214
Parameter setting value x
f215
2: Upper limit
frequency
ul
Parameter setting value x
f214
Parameter setting value x
f215
5: Torque boost
value
vb
,
f172
Parameter setting value x
f214
Parameter setting value x
f215
6: Stall prevention
level
f185 , f601
Parameter setting value x
f214
Parameter setting value x
f215
7: Motor electronic-
thermal protection
level thr , f173
Parameter setting value x
f214
Parameter setting value x
f215
11: Base frequency vlv , f171
Parameter setting value x
f214
Parameter setting value x
f215
Note: Adjustments are made by the inverter itself, so no changes are made to parameter settings