Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 173 / 434

E6581611
E-18
5
3) Using other speed commands with preset-speed command
Command mode
selection

0: Terminal block
1: Panel keypad (including extension panel)
2: RS485 communication
3: CANopen communication
4: Communication option
Frequency setting
mode selection

0:Setting dial 1 (save even if power is off)
1: Terminal VIA
2: Terminal VIB
3: Setting dial 2 (press in center to save)
4: RS485 communication
5: UP/DOWN from external logic input
6: CANopen communication
7: Communication option
8: Terminal VIC
9, 10: -
11: Pulse train input
12, 13: -
14:
sr0
Active Preset-speed command valid Note)
Preset-
speed
command Inactive Command set with fmod is valid
0:Setting dial 1 (save even if power is off)
1: Terminal VIA
2: Terminal VIB
3: Setting dial 2 (press in center to save)
4: RS485 communication
5: UP/DOWN from external logic input
6: CANopen communication
7: Communication option
8: Terminal VIC
9, 10: -
11: Pulse train input
12, 13: -
14:
sr0
Note) The preset-speed command is always given priority when other speed commands are input at the same time.
An example of three-speed operation with the default settings is shown below.
(Frequency settings are required for
 to  .)
F-CC
S1(SS1)-CC
S2(SS2)-CC
ON
OFF
ON
OFF
ON
OFF



Output frequency
Time
0
(The inverter doesn't accept
Preset-speed command.)