Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 334 / 434

E6581611
G-10
7
 List of output terminal function settings
List of detection levels for output terminal selection
Parameter
programmed value
Parameter
programmed value
Positive
logic
Negative
logic
Function
Positive
logic
Negative
logic
Function
   
Frequency lower limit
 
Heavy load output
    Frequency upper limit   Lower limit frequency stop
    Low-speed detection signal   Power failure synchronized operation
    Output frequency attainment signal
(acceleration/deceleration completed)   Traverse in progress
   
Set frequency attainment signal
 
Traverse deceleration in progress
    Fault signal (trip output)   Parts replacement alarm
    Over-current detection pre-alarm   Over-torque detection pre-alarm
    Overload detection pre-alarm   Frequency setting mode selection 1/2
   
Overheat detection pre-alarm
 
Panel / remote selection
    Overvoltage detection pre-alarm   Forced continuous operation in progress
   
Power circuit undervoltage detection
 
Specified frequency operation in progress
    Small current detection   Signal in accordance of frequency
command
    Over-torque detection   Fault signal (output also at a retry waiting)
   
Braking resistor overload pre-alarm
 
PTC input alarm signal
   
Run/Stop
 
Factory specific coefficient *1
    Serious failure   Analog input break detection alarm
    Light failure   F terminal status
   
Cooling fan ON/OFF
 
R terminal status
   
In jogging operation
 
Cooling fan replacement alarm
    Operation panel / terminal block
operation
  Number of starting alarm
    Cumulative operation time alarm   Acceleration operation in progress
   
Communication option
communication error
 
Deceleration operation in progress
   
Forward/reverse run
 
Constant speed operation in progress
    Ready for operation 1   DC braking in progress
    Ready for operation 2  to  Factory specific coefficient *1
   
Brake release
180 181
Integral input power pulse output signal
   
Pre-alarm
182 183
Shock monitoring pre-alarm signal
    RS485 communication error  to  Factory specific coefficient *1
    Designated data output 1  Always OFF
   
Designated data output 2

Always ON
 
Light load output

*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
<Explanation of terminology>
 Alarm …... Alarm output when a setting has been exceeded.
 Pre-alarm …... Alarm output when the inverter may cause a trip during continued operation.