Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 171 / 434

E6581611
E-16
5
5.7 Preset-speed operation (speeds in 15 steps)
sr0 to sr7 : Preset-speed frequency 0 to 7
f287
to
f294
: Preset-speed frequency 8 to15
f724 : Operation frequency setting target by setting dial

Function
A maximum of 15 speed steps can be selected just by switching an external logic signal. Multi-speed
frequencies can be programmed anywhere from the lower limit frequency
 to the upper limit frequency

.
[Setting method]
1) Run/stop
The starting and stopping control is done from the terminal block.
Title Function Adjustment range Setting
 Command mode selection
0: Terminal block
1: Panel keypad (including extension panel)
2: RS485 communication
3: CANopen communication
4: Communication option
0
2)
Preset-speed frequency setting
a) Set the speed (frequency) of the number of steps necessary.
[Parameter setting]
Preset-speed 0
Title Function Adjustment range Default setting
sr0
Preset-speed frequency 0
 - 
(Hz) 0.0
fmod
Frequency setting mode selection 1
0-13
14:
sr0
0
Frequency command set with sr0 is valid when fmod = 14 ( sr0 ).
(
sr0
is valid even when the command mode selection is not
cmod
=
0
.)
Setting from speed 1 to speed 15
Title Function Adjustment range Default setting
 - 
Preset-speed frequency 1-7
 - 
(Hz) 0.0

Preset-speed frequency 8-15
 
(Hz)

0.0
b) Speed (frequency) can be changed during operation.
Title Function Adjustment range Setting

Operation frequency setting target
by setting dial
0: Panel frequency ( fc )
1: Panel frequency (
fc
)
+ Preset speed frequency
1
When f724 = 1 , speed (frequency) can be changed with the setting dial during operation. Set value of the
Preset-speed frequency will change by pressing the center.