Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 329 / 434

E6581611
G-5
7
 List of logic input terminal function settings
Parameter
programmed value
Parameter
programmed value
Positive
logic
Negative
logic
Function
Positive
logic
Negative
logic
Function
   
No function
   
Integrating wattmeter (kWh) display
clear
   
Forward run command
   
Trace back trigger signal
   
Reverse run command
   
Light-load high-speed operation
prohibitive signal
    Standby     Holding of RY-RC terminal output
    Reset command     Holding of OUT-NO terminal output
    Preset-speed command 1     Frequency UP *2
    Preset-speed command 2     Frequency DOWN *2
   
Preset-speed command 3
   
Clear frequency UP/DOWN *2
   
Preset-speed command 4
   
Coast stop command
   
Jog run mode
   
Forward/reverse selection
   
Emergency stop by external signal
 
Run/Stop command
   
DC braking command
  Frequency reference command forced
switching
    2nd acceleration/deceleration   Frequency setting mode terminal block
    3rd acceleration/deceleration   Command mode terminal block
    2nd V/F control mode switching   Parameter editing permission
   
2nd stall prevention level
 
Fast stop command 1
   
PID control prohibition
 
Fast stop command 2
   
External thermal error input
 
Traverse permission signal
   
Forced local from communication
 
Low voltage operation
    Operation hold (hold of 3-wire operation)   Forward deceleration
    PID integral/differential clear   Forward stop
    PID characteristics switching   Reverse deceleration
    Forced run operation   Reverse stop
    Fire speed operation  to  Factory specific coefficient *1
   
Acceleration/deceleration suspend signal
 
No.2 motor switching
   
Power failure synchronized signal
 
Parameter editing prohibition
    Factory specific coefficient *1   Parameter reading prohibition
    Factory specific coefficient *1  
*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
*2: Active when

(frequency setting mode selection) =

(UP/DOWN from external logic input) is set.
The frequency setup range is from  to  (maximum frequency). The acceleration/deceleration time
relative to the set frequency is

/

while the acceleration/deceleration speed is not switched.
☆
Refer to section 11.6 for details about the input terminal function.