Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 305 / 434

E6581611
F-125
6
Title Function Adjustment range Default setting
f734 
Panel emergency stop operation
prohibition
0: Permitted, 1: Prohibited 0
f735  Panel reset operation prohibition 0: Permitted, 1: Prohibited 0
f736 
cmod
/
fmod
change prohibition
during operation
0: Permitted, 1: Prohibited 1

All key operation prohibition 0: Permitted, 1: Prohibited 0
f738  Password setting ( f700 )
0: Password unset
1-9998
9999: Password set
0
f739  Password verification
0: Password unset
1-9998
9999: Password set
0
,
Parameters can be edited regardless of the setting of
f700
by assigning the parameter editing
permission (function number 110, 111) to an input terminal.
Note1:
f700
=
2
and
4
will be available after reset operation.
When protection using a password is necessary, set and remove with the following method.
■ Password setup method
Preparation: Parameters other than f700 , f738 , and f739 cannot be changed when f700 is set
to
1
to
4
.
(1) When f738 or f739 is read out and the value is 0 , a password hasn’t been set.
You can set a password.
(2) When f738 or f739 is read out and the value is 9999 , a password has already been set.
(3) You can set a password If it hasn’t been set. Select and register a number from
1
to
9998
for
f738
.
The number is the password. Do not forget your password as it is required to release the lock.
(4) The settings for parameter
f700
cannot be changed.
Note2: The lock cannot be released If you forget the password. Do not forget this password as we cannot
retrieve it.
Note3: Password cannot be set when parameter f700 = 0 .
Set the password after parameter
f700
=
1
to
4
.
Note4: Password can be read out to parameter writer (optional device) only for 5 minutes after setting

. Please note that password will not be able to read out due to password protection after 5
minutes have elapsed or when the power is off.
■ Password examination method
(1) When
f738
or
f739
are read out and the value is
9999
, a password has already been set.
Password has to be removed in order to change parameters.
(2) Enter a the number (
1
to
9998
) registered to
f739
when the password was set for
f738
.
(3) If the password matches, pass blinks on the display and the password is removed.
(4) If the password is incorrect,
fail
blinks on the display and
f739
is displayed again.
(5) When the password is removed, the setting for parameter f700 can be changed.
(6) By setting parameter
f700
=
0
, the all parameter settings can be changed.
Note5: Entry of  setting is possible up to 3 times. Please note it is impossible to set, if you enter the
wrong number for 3 times. Number of times is reset after power is off.