Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 315 / 434

E6581611
F-135
6
6.38 Communication function
6.38.1 Setting of communication function
f800
: Baud rate
f814
: Communication command

f801 : Parity point 2 frequency 
f802 : Inverter number f829 : Selection of communication
f803
: Communication time-out time protocol
f804
: Communication time-out action
f856
: Number of motor poles for

f805
: Communication waiting time communication
f806 : Setting of master and slave for f870 : Block write data 1
communication between inverters f871 : Block write data 2
f808
: Communication time-out
f875
: Block read data 1
detection condition
f876
: Block read data 2
f810
: Communication command point selection
f877
: Block read data 3
f811 : Communication command point 1 setting f878 : Block read data 4 
f812 : Communication command point 1 frequency f879 : Block read data 5 
f813
: Communication command point 2 setting
f899
: Communication function reset
Warning
Mandatory
action
•
Set the parameter Communication time-out time ( f803 ) , Communication time-out action ( f804 )
and Disconnection detection of extension panel ( f731 ).
If these are not properly set, the inverter cannot be stopped immediately in breaking communication and
this could result in injury and accidents.
•
An emergency stop device and the interlock that fit with system specifications must be installed.
If these are not properly installed, the inverter cannot be stopped immediately and this could result in
injury and accidents.
Refer to “Communication Function Instruction Manual : E6581913” for details.