Toshiba Q9 Plus ASD, Installation & Operation Manual

Page: 194 / 434

E6581611
F-14
6

:
Terminal VIC
A frequency command is set by means of external analog signals.
(VIC terminal: 0 (4) - 20mAdc)
⇒
Refer to section 3.2.2 and 7.3

:
Pulse train input
A frequency command is set by means of external pulse train signals.
(S2 terminal: 10pps
- 2kpps)
⇒
Refer to section 6.6.5
14 :
sro
Frequencies are set by sro parameter.
⇒ Refer to section 3.6.
,
The control input terminal in which the following functions are set is always valid regardless of the setting of
 and  .
 Reset (valid only for tripping)

Standby
 External input tripping stop command

Coast stop command terminal
,
To make changes in the command mode selection

and the frequency setting mode selection 1
 , first stop the inverter temporarily.
(Can be changed while in operation when

is set to

.)
,
Priority commands from communications or terminal blocks are given priority over  .
 Preset-speed operation
 : Set to  (Terminal block operation)

: Valid in all setting values.

Input terminal settings
Assign the following functions to the input terminal to allow switching of the frequency command by turning
the terminal ON/OFF.
Input terminal function ON OFF
48 Forced local from communication
Enabled during communication
Local (Setting of
 , 
)
Communication
106
Frequency setting mode terminal
block
Terminal block (VIA) enabled setting of

Each of the following numbers (49, 107) are reverse signals.