Chapter 8: Using the Command Line Interface
409
Setting the Outlet Initialization Delay
This section applies to outlet-switching capable models only.
This command determines the outlet initialization delay timing on device
startup. See
PDU
(on page 145) for information on outlet initialization
delay.
config:#
pdu outletInitializationDelayOnDeviceStartup <timing>
Variables:
<timing> is a delay time between 1 and 3600 seconds.
Note: This feature does NOT take effect and cannot be configured on a
PX3 device after the outlet relay is set to the "Latching" mode. See
PX3
Latching Relay Behavior
(on page 150).
Specifying Non-Critical Outlets
This section applies to outlet-switching capable models only.
This command determines critical and non-critical outlets. It is
associated with the load shedding mode. See
Load Shedding Mode
(on
page 164).
config:#
pdu nonCriticalOutlets <outlets1>:false;<outlets2>:true
Separate outlet numbers and their settings with a colon. Separate each
"false" and "true" setting with a semicolon.
Variables:
<outlets1> is one or multiple outlet numbers to be set as critical
outlets. Use commas to separate outlet numbers.
Use a dash for a range of consecutive outlets. For example,
3-8
represents outlets 3 to 8.
<outlets2> is one or multiple outlet numbers to be set as
NON-critical outlets. Use commas to separate outlet numbers.
Use a dash for a range of consecutive outlets. For example,
3-8
represents outlets 3 to 8.
Summary of Contents for PX3-1000 series
