Raritan PX3-1000 series, User Manual

Page: 436 / 744

Chapter 8: Using the Command Line Interface
414
Interface Description
bridge Determine the IPv4 configuration mode of the
BRIDGE interface (that is, bridging mode).

<mode> is one of the modes:
dhcp or static.
Mode Description
dhcp The IPv4 configuration mode is set to DHCP.
static The IPv4 configuration mode is set to static IP
address.
Setting the IPv4 Preferred Host Name
After selecting DHCP as the IPv4 configuration mode, you can specify the
preferred host name, which is optional. The following is the command:
config:# network ipv4 interface <ETH> preferredHostName <name>
Variables:

<ETH> is one of the network interfaces:
ethernet (or ETH1/ETH2),
wireless, bridge or all. Note that you must choose/configure the
bridge interface if your PX3 is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET (or
ETH1/ETH2) and WIRELESS interfaces do NOT function.
Interface Description
ethernet (PX3) Determine the IPv4 preferred host name of the
ETHERNET interface (that is, wired networking).
eth1 (PX3-iX7) Determine the IPv4 preferred host name of the
ETH1 interface (that is, wired networking).
eth2 (PX3-iX7) Determine the IPv4 preferred host name of the
ETH2 interface (that is, wired networking).
wireless Determine the IPv4 preferred host name of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv4 preferred host name of the
BRIDGE interface (that is, bridging mode).