Chapter 6: Using the Web Interface
173
To view this OCP's power waveform:
This OCP's RMS current data in waveform is shown in the Overcurrent
Protector History section.
To configure this OCP's threshold settings:
1.
Click the Thresholds title bar at the bottom of the page to display the
threshold data.
2.
Click the RMS current sensor (required), and then click Edit
Thresholds.
3.
Make changes as needed.
To enable any threshold, select the corresponding checkbox.
Type a new value in the accompanying text box.
For concepts of thresholds, deassertion hysteresis and assertion
timeout, see
Sensor Threshold Settings
(on page 675).
4.
Click Save.
Summary of Contents for PX3-1000 series
