Appendix L: Integration
704
Power Control
The KSX II operation to turn on/off or power cycle a PX is the same as the
KX III operation. See
Turning Outlets On/Off and Cycling Power
(on
page 700).
Dominion SX and SX II
By connecting to a Dominion SX or SX II device, you can associate one or
more outlets on a PX3 device to specific SX or SX II ports.
Dominion SX II
The way to use Dominion SX II to configure and control a Raritan PDU is
similar to using Dominion KX III, but the connection method is different
from KX III.
Note: If using a CSCSPCS-1 cable for the connection, it must be "Rev.0C".
If using a CSCSPCS-10 cable, it must be "Rev.0D".
Note that the appliances used in the diagram may not match your
specific models. However, the connections and ports used are the same
across models.
To connect the SX II to the Feature port on the PX:
1.
Connect the gray end of the CSCSPCS crossover Cat5 cable into the
Feature port on the PX.
2.
Connect the yellow end of the CSCSPCS crossover Cat5 cable into a
port on the SX II.
3.
Power on the PX (if it is not already).
Summary of Contents for PX3-1000 series
