Raritan PX3-1000 series, User Manual

Page: 59 / 744

Chapter 3: Initial Installation and Configuration
37

Wireless IPv4 / IPv6 settings:
Commands for wireless IP settings are identical to those for wired
networking. Just replace the variable <ETH> with the word 'wireless'.
The following illustrates a few examples.
To set or
enable Use this command
IPv4
configuration
method
network ipv4 interface WIRELESS
configMethod <mode>
<mode> = dhcp (default) or static
IPv6
configuration
method
network ipv6 interface WIRELESS
configMethod <mode>
<mode> = automatic (default) or static
To verify network settings:
After exiting the above configuration mode and the # prompt re-appears,
type this command to verify all network settings.
show network
The IP address configured may take seconds to take effect.
Bulk Configuration Methods
If you have to set up multiple PX3 devices, you can use one of the
following configuration methods to save your time.
Use a bulk configuration file:

Requirement: All PX3 devices to configure are of the same model
and firmware.

Procedure: First finish configuring one PX3. Then save the bulk
configuration file from it and copy this file to all of the other PX3
devices.
See
Bulk Configuration
(on page 344).
Use a TFTP server:

Requirement: DHCP is enabled in your network and a TFTP server is
available.

Procedure: Prepare special configuration files, which must include
fwupdate.cfg, and copy them to the root directory of the TFTP server.
Re-boot all PX3 after connecting them to the network.
See Bulk Configuration or Firmware Upgrade via DHCP/TFTP (on
page 562).