Appendix G: Old PX3 Character LCD Display
619
Number
Device position
3 Slave
3
4 Slave
4
5 Slave
5
6 Slave
6
7 Slave
7
As of release 3.3.10, the port forwarding mode supports up to 15 slave
devices so the numbers 8 to 15 may be shown in this mode.
RCM Information
If your "old" PX3 model supports residual current monitoring (RCM), this
information is available in the front panel LCD display. For more
information on RCM, see
PX3 Models with Residual Current
Monitoring
(on page 588).
The front panel LCD display shows an alarm message when the RCM
enters the critical state. Besides, you can operate the LCD display to
check the RCM status.
Note: For the RCM information shown on the dot-matrix LCD display, see
Front Panel Operations for RCM
(on page 594).
RCM alarm information in the critical state:
In the RCM critical state, the PDU beeps and the LCD display indicates
the RCM critical state.
The RCM alarm information continues to display as long as RCM is in a
critical state. The following RCM alarm messages are displayed one by
one in the critical state.
rCA --> rCA --> Residual current value (mA)
The diagram below illustrates the RCM alarm on the LCD display.
To display the RCM current:
1.
Press the MODE button until the term "INLET" is displayed.
Summary of Contents for PX3-1000 series
