Chapter 2: Rackmount, Inlet and Outlet Connections
9
Mounting Zero U Models Using Button Mount
If your PDU has circuit breakers implemented, read
Circuit Breaker
Orientation Limitation
(on page 6) before mounting it.
To mount Zero-U models using button mount:
1.
Align the baseplates on the rear of the PX3 device. Leave at least 24
inches between the baseplates for stability.
2.
Make the baseplates grasp the device lightly. Use the included
L-shaped hex key to loosen the hex socket screws until the
baseplate is "slightly" fastened.
3.
Screw each mounting button in the center of each baseplate. The
recommended torque for the button is 1.96 N·m (20 kgf·cm).
4.
Align the large mounting buttons with the mounting holes in the
cabinet, fixing one in place and adjusting the other.
Summary of Contents for PX3-1000 series
