3-19
Key
sequence
Explanation
Display
example
Indicator
Use the Increment or Decrement Key to
display to set the data, during which the
display flashes.
0: Parameter read-prohibit (No data can be
written to the EEPROM)
1: Parameter read possible (Data can be
written to the EEPROM)
Press the Enter Key so that the set value will
be entered and the data display will be lit.
In
approximately
1 s.
The parameter number will be displayed
again in approximately 1 s.
3-2-4 Parameter Copy or Verify Errors
·
The following description provides information on errors that may result while the
parameter set values are read, copied, or verified, and the remedies to be taken. The
display flashes while displaying these errors.
Display
Name
Probable cause
Remedy
pre
Protection error
An attempt was made to
read the parameter set
values while n177 for
parameter read-prohibit
selection was set to 0.
Set n177 to 1 and retry after
rechecking the necessity of
reading the parameter set
values.
rde
Read error
The parameter set values
were not read correctly or a
main-circuit low voltage was
detected while the
parameter set values were
read.
Retry after checking that the
voltage of the main circuit is
normal.
cse
Checksum error
A checksum error resulted in
the parameter set values in
the EEPROM of the Digital
Operator.
Read the parameter set
values again and store them
in the EEPROM.
nde
No data error
There are no parameter set
values stored in the
EEPROM of the Digital
Operator.
Read the parameter set
values and store them in the
EEPROM.
Preparing for Operation and Monitoring
Chapter 3
Summary of Contents for SYSDRIVE 3G3MV A2002
