Omron SYSDRIVE 3G3MV A2002, User Manual

Page: 317 / 348

10-7
Param-
eter
No.
Regis-
ter No.
Name Description Set-
ting
range
Unit
of
set-
ting
Default
setting
Changes
during
opera-
tion
Ref-
er-
ence
page
n024 0118 Frequency
reference 1
Used to set internal frequency refer-
ences.
0.0 to
max.
fre-
0.01
Hz
(chan
6.00 Yes 5-20
n025 0119 Frequency
reference 2
ences.
Note Frequency reference 1 is
enabled in remote mode with
n004 for frequency reference
fre-
quency
(chan
ge in
n035)
0.00 Yes 5-20
n026 011A Frequency
reference 3
enabled in remote mode with
n004 for frequency reference
selection set to 1.
n035)
0.00 Yes 5-20
n027 011B Frequency
reference 4
selection set to 1.
Note These frequency references
are selected with multi-step 0.00 Yes 5-20
n028 011C Frequency
reference 5
are selected with multi-step
speed references (multi-func-
tion input). See the reference
pages for the relationship
0.00 Yes 5-20
n029 011D Frequency
reference 6
tion input). See the reference
pages for the relationship
between multi-step speed ref-
erences and frequency refer-
0.00 Yes 5-20
n030 011E Frequency
reference 7
between multi-step speed ref-
erences and frequency refer-
ences.
0.00 Yes 5-20
n031 011F Frequency
reference 8
ences.
0.00 Yes 5-20
n032 0120 Inching fre-
quency com-
mand
Used to set the inching frequency
command.
Note The inching frequency com-
mand is selected with the inch-
ing command (multi-function
input). The inching frequency
command takes precedence
over the multi-step speed refer-
ence.
6.00 Yes 5-23
n033 0121 Upper fre-
quency refer-
ence limit
Used to set the upper and lower fre-
quency reference limits in percentage
based on the maximum frequency as
100%.
Note If n034 is set to a value less than
the minimum output frequency
0 to
110
1% 100 No 5-13
n034 0122 Lower fre-
quency refer-
ence limit
Note If n034 is set to a value less than
the minimum output frequency
(n14), the Inverter will have no
output when a frequency refer-
ence less than the minimum
output frequency input is input.
0 to
110
1% 0 No 5-13
List of Parameters Chapter 10