Omron SYSDRIVE 3G3MV A2002, User Manual

Page: 182 / 348

6-40
Note If set to vector control mode, the default value will be 0.2.
Set Values
·
This parameter is used for the response adjustment of the slip compensation function.
·
The default setting does not need any changes in normal operation.
·
Change the default setting in the following cases.
The motor vibrates: Set the value to a larger value.
The motor response is low: Set the value to a smaller value.
n113 Slip Compensation During
Regeneration
Register 0171
Hex
Changes during
operation
No
Setting
range
0, 1 Unit of
setting
1 Default setting 0
Set Values
Value Description
0 Slip compensation function disabled during regeneration
1 Slip compensation function enabled during regeneration
·
Select whether the slip compensation function is enabled or not, even during regen-
eration (i.e.: when regeneration energy is returning during deceleration, etc.).
·
This parameter is only enabled in vector control mode. (In V/f control mode, the slip
compensation function will be disabled during regeneration, regardless of the setting
for this parameter.)
Advanced Operation Chapter 6