Omron SYSDRIVE 3G3MV A2002, User Manual

Page: 218 / 348

7-24
7-6 Register Number Allocations in Detail
The following description provides information on register numbers allo-
cated to the Inverter and the meanings of the registers. As for the register
numbers of the parameters (n001 through n179), refer to
Section 10 List of
Parameters and the description of each of these parameters wherever
explained in this manual.
7-6-1 I/O Function
H
Communications with a Single Slave with Addresses 01 to 32
(01 to 20 Hex) Read/Write
Register No.
(Hex)
Function Description
0000 Not used ---
0001 RUN command Refer to the table below.
0002 Frequency reference Set the frequency reference in the unit
according to the set value in n152.
0003 V/f gain Set on condition that 100% is 1000 within a
range from 2.0 to 200.0% (20 to 2000). (see
note 1)
0004 to 0008 Not used ---
0009 Inverter output Refer to the table below.
000A to 000F Not used ---
Note 1. The V/f gain is a rate to be multiplied by the output voltage obtained from V/f
operation. If 1000 (03E8 Hex) is set, the multiplication rate will be 1.
Note 2. When the above registers are read, values that are set through communica-
tions will be read. For example, when the RUN command (register 0001) is
read, the control input in the register that was previously set through commu-
nications will be returned. This is not a value monitored through the input signal
terminal.
Communications Chapter 7