NXP Semiconductors MPC5605BK, Reference Manual

Page: 40 / 964

Chapter 2 Introduction
MPC5606BK Microcontroller Reference Manual, Rev. 2
40 Freescale Semiconductor
2.4.10 Deserial Serial Peripheral Interface Module (DSPI)
The DSPI features the following:
• As many as six DSPI modules supported
• Full duplex, synchronous transfers
• Master or slave operation
• Programmable master bit rates
• Programmable clock polarity and phase
• End-of-transmission interrupt flag
• Programmable transfer baud rate
• Programmable data frames from 4 to 16 bits
• As many as six chip select lines available, depending on package and pin multiplexing, to enable
64 external devices to be selected using external muxing from a single DSPI
• As many as eight transfer types, independently configurable for each DSPI using the clock and
transfer attributes registers
• Chip select strobe available as alternate function on one of the chip select pins for deglitching
• FIFOs for buffering as many as four transfers on the transmit and receive side
• General purpose I/O functionality on pins when not used for SPI
• Queueing operation possible through use of eDMA
• 32-bit serialization of data enabling virtual GPIO ports on 2 DSPI modules
2.4.11 Controller Area Network module (FlexCAN)
The enhanced FlexCAN module features the following:
• As many as six FlexCAN modules supported
Table 2-5. eMIOS configuration
Channel type
Maximum number of channels
Total
eMIOS_0 eMIOS_1
Counter / OPWM / ICOC
1
1
Each channel supports a range of modes including Modulus counters, PWM generation, Input Capture, Output
Compare.
5 5 10
O(I)PWM / OPWFMB / OPWMCB / ICOC
2
2
Each channel supports a range of modes including PWM generation with dead time, Input Capture, Output
Compare.
7 0 7
O(I)PWM / ICOC
3
3
Each channel supports a range of modes including PWM generation, Input Capture, Output Compare, Period and
Pulse width measurement.
7 7 14
OPWM / ICOC
4
4
Each channel supports a range of modes including PWM generation, Input Capture, Output Compare.
13 20 33