1. Align the keyway in sprocket (D) with the key on the
motor shaft, and slide the sprocket onto the shaft.
Secure with
fl
at washer (C) and slotted nut (B).
2. Torque slotted nut (B) to 40 ft·lbf (54 N
·
m).
3. Install cotter pin (A). If necessary, tighten the slotted
nut (B) to the next slot to install the cotter pin.
Figure 5.264: Reel Drive
4. Install the drive chain (A) onto the drive sprocket (B).
5. Tighten the drive chain. Refer to
Figure 5.265: Reel Drive
5.14.4
Replacing Double-Reel U-Joint
The double-reel drive U-joint allows each reel to move independently from the other.
Lubricate the U-joint according to the speci
fi
cations. Refer to
5.3.6 Lubrication and Servicing, page 303
Replace the U-joint if severely worn or damaged. Refer to
Removing Double-Reel U-Joint, page 431
Removing Double-Reel U-Joint
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
1. Shut down the combine, and remove the key from
the ignition.
2. Remove the drive cover. Refer to
147831
431
Revision A
Summary of Contents for FlexDraper FD1 Series
