1. Apply talc, baby powder, or talc/graphite lubricant
mix to the draper surface that forms the seal with the
cutterbar and to the underside of the draper guides.
2. Insert the draper into the deck at the outboard end
under the rollers. Pull the draper into the deck while
feeding it at the end.
3. Feed in the draper until it can be wrapped around the
drive roller.
4. Insert the opposite end of the draper into the deck over
the rollers. Pull the draper fully into the deck.
Figure 5.161: Installing Draper
5. Loosen the mounting bolts (B) on the rear deck
de
fl
ector (A) (this may help with draper installation).
Figure 5.162: Draper Seal
6. Attach the ends of the draper with tube connectors (B),
screws (A) (with the heads facing the center opening),
and nuts.
7. Adjust the draper tension. Refer to
Figure 5.163: Draper Connector
147831
387
Revision A
Summary of Contents for FlexDraper FD1 Series
