5. Read the warning message, and then press the green
check mark button.
Figure 3.178: Challenger Combine Display
6. Follow the on-screen prompts to complete calibration.
NOTE:
The calibration procedure can be cancelled at
anytime by pressing the cancel button in the
bottom right corner of the screen. While the
header calibration is running, the calibration can
also be canceled by using the up, down, tilt right,
or tilt left buttons on the control handle.
NOTE:
If the combine does not have header tilt installed
or if it is inoperable, you may receive warnings
during calibration. Press the green check mark
if these warnings appear. This will not affect the
AHHC calibration.
Figure 3.179: Challenger Combine Display
Adjusting the Header Height (Challenger and Massey Ferguson)
Once the auto header height control (AHHC) is activated, press and release the HEADER LOWER button on the
control handle. The AHHC will automatically lower the header to the selected height setting.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
147831
128
Revision A
Summary of Contents for FlexDraper FD1 Series
