1. Raise the header fully and engage the header
safety props.
2. Swivel the front wheel assembly (A) so the wheels are
aligned with the lower frame.
3. Remove pin (B) and pull the wheel assembly towards
the rear of header. Store the pin in hole (C) at the top
of the leg.
4. Pull handle (D) upwards to release and lower the
linkage into the vertical support.
Figure 3.343: Front (Left) Wheels
5. Align lift hook (A) with lug (B) and lift the wheel
assembly to engage the pin in the lift hook. Ensure
latch (C) is engaged.
6. Install clevis pin (D) and secure to the center of the axle
with hairpin.
Figure 3.344: Front (Left) Wheels
147831
213
Revision A
Summary of Contents for FlexDraper FD1 Series
