![background image](http://html.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_operators-manual_685695161.webp)
Figure 3.201: John Deere Combine Display
4. If the sensor voltage is not within the low and high limits or if the range between the low and high limits is
insuf
fi
cient, refer to
Adjusting Voltage Limits (One-Sensor System), page 106
.
Calibrating the Auto Header Height Control (John Deere 60 Series)
For best performance of the auto header height control (AHHC), perform these procedures with the center-link
set to D. When setup and calibration are complete, adjust the center-link back to desired header angle. Refer to
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Ensure center-link is set to D.
2. Rest header on down stops, and unlock
fl
oat module
fl
oat.
3. Put wings in locked position.
4. Start the combine.
147831
143
Revision A
Summary of Contents for FlexDraper FD1 Series
