4.8.2
Attaching Header to Float Module
The FD1 header can be attached to the
fl
oat module from either
fi
eld or transport con
fi
guration.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
NOTE:
Stabilizer/Slow Speed Transport wheels can be used to support the header. Refer to
1. Prop up the hydraulic center-link (A) with a pin (or
equivalent tool) at location (B) as shown.
Figure 4.152: Center-Link
2. Ensure the latches (A) at the front corners of the
fl
oat
module are rotated towards the rear of the
fl
oat module.
Figure 4.153: Latch
147831
290
Revision A
Summary of Contents for FlexDraper FD1 Series
