MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 247 / 510

HEADER ATTACHMENT/DETACHMENT
4.1.2 Converting from Configuration C to Configuration A
One kit (MD #287031) is required to convert to this con fi guration.
Auger con fi guration A shown at right. Flighting (A) is
installed when converting from con fi guration C.
Figure 4.10: Configuration A (Rear View)
NOTE:
Some parts are removed from the illustration for clarity.
1. Remove bolts (A) and remove the access cover (B).
Retain for reassembly later.
2. Remove and discard the two fl ighting slot plugs (C).
Figure 4.11: Configuration C (RH Side)
3. Install fl ighting (MD #213359) (A) on the right-hand
side as shown, and secure with six carriage head
bolts (MD #184657) and six nuts (MD #135799) at
location (B).
IMPORTANT:
Bolt heads must be installed on inside of auger
to prevent damage to internal components.
4. Torque all nuts to 35 ft · lbf (47 N · m) to eliminate
de fl ection on fl ighting, then torque all nuts and bolts
on fl ighting to 43–47 ft · lbf (58–64 N · m).
Figure 4.12: Configuration A (RH Side)
147831
229
Revision A