1. Lower the reel fully, shut down engine, and remove key
from ignition.
2. Loosen two center lock
fl
ange nuts (A), and adjust
sensor mounting bracket (B) until the threaded rod (C)
is parallel with the sensor arm (D). Tighten center lock
fl
ange nuts.
Figure 3.87: Reel Height Sensor – Right-Hand
Reel Arm
3. Lower the reel fully.
4. Use the combine display or a voltmeter (if measuring
the sensor manually) to measure the upper voltage
range between the ground (Pin 2) and signal (Pin 3)
wires at the reel height sensor (C).
5. Adjust length of threaded rod (A) to achieve an upper
voltage range of 4.1–4.5 V.
6. Raise the reel fully and use combine display or
a voltmeter (if measuring the sensor manually) to
measure the lower voltage range. Loosen two M5
hex nuts (B) and rotate sensor (C) to achieve a lower
voltage range of 0.5–0.9 V.
7. Lower the reel fully and recheck the upper voltage
range to ensure it is still within the 4.1–4.5 V tolerance.
If the upper voltage range is not within the correct
tolerance, repeat adjustment procedure from Step
.
Figure 3.88: Reel Height Sensor – Right-Hand
Reel Arm
147831
81
Revision A
Summary of Contents for FlexDraper FD1 Series
