
10. Push the handle (A) on the combine to the fully open
position.
11. Clean the mating surfaces of the multicoupler (B) and
receptacle if necessary.
Figure 4.71: Combine Receptacle
12. Position the multicoupler (A) onto the combine
receptacle, and pull the handle (B) to fully engage the
multicoupler into the receptacle.
13. Connect
the
reel
fore-aft/header
tilt
selector
harness (C) to the combine harness (D).
Figure 4.72: Multicoupler
14. Pull handle (A) to release bolt from slot and remove the
driveline from the support bracket (B).
Figure 4.73: Driveline
147831
255
Revision A
Summary of Contents for FlexDraper FD1 Series
