MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 394 / 510

MAINTENANCE AND SERVICING
4. Slide left-hand end of drive roller (A) onto spline of
motor (B).
Figure 5.137: Motor
5. Secure the bearing and housing (A) with the drive roller
cover plate on the frame using two bolts (B).
6. Install the feed deck draper. Refer to
5.10.1 Replacing
Feed Draper, page 371
.
7. Tension the feed draper. Refer to
5.10.2 Adjusting
Feed Draper Tension, page 372
.
Figure 5.138: Drive Roller Bearing
Replacing Feed Draper Drive Roller Bearing – FM100
Removing Feed Draper Drive Roller Bearing – FM100
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator’s seat, and always engage safety props before going under
the machine for any reason.
1. Raise the header to its full height, stop the engine, and the remove key from the ignition.
2. Engage the header safety props.
3. Raise reel and engage safety stops.
147831
376
Revision A