MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 129 / 510

OPERATION
Figure 3.140: Joystick Lever (Case IH
5088/6088/7088)
Setting the Sensitivity of the Auto Header Height (Case IH 2500 and 5088/6088/7088)
The sensitivity adjustment controls the distance the cutterbar must travel up or down before the auto header height
control (AHHC) reacts and raises or lowers the feeder house. When the sensitivity is set to maximum, only small
changes in ground height are needed to cause the feeder house to raise or lower. When the sensitivity is set to
minimum, large changes in the ground height are needed to cause the feeder house to raise or lower.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
1. Use the HEADER SETTINGS key (M) to display the
HEADER SENSITIVITY CHANGE page.
2. Use the UP or DOWN keys (E and H) to adjust
the highlighted item. The height sensitivity setting
range is 0 (least sensitive) to 250 (most sensitive) in
increments of 10.
NOTE:
Adjustments take effect immediately. Use the
CANCEL key to return to the original settings.
3. Use the HEADER SETTINGS key (M) to highlight the
next changeable item.
4. Use the ENTER key (D) to save changes and return to
the monitor page. If there are no changes, the screen
will return to the monitor page after
fi ve seconds.
Figure 3.141: Combine Controls
147831
111
Revision A