MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 303 / 510

HEADER ATTACHMENT/DETACHMENT
4.8 Attaching and Detaching Header from Float Module
Attaching/detaching procedures are the same for all makes and models of combines. Headers can be attached to
the
fl oat module from either fi eld or transport con fi gurations.
The procedures in this manual require that the fl oat module remains attached to the combine. Attach/detach the
fl oat module only if performing the following tasks:
• Detaching the header for use on a windrower
• Changing headers
• Performing certain maintenance tasks
4.8.1 Detaching Header from Float Module
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
WARNING
Keep hands clear of the area between guards and
knife at all times.
CAUTION
Wear heavy gloves when working around or
handling knives.
Figure 4.139: Cutterbar Hazard
1. Start the engine and the lower header.
2. Increase clearance under the fl oat module feed draper
by tilting the header until the cylinder (B) is fully
extended and the indicator (A) is at position D.
3. Raise the reel to its full height.
4. Stop the engine and the remove key from the ignition.
5. Engage the reel safety props.
Figure 4.140: Center-Link
147831
285
Revision A