Reposition the center arm cylinder as follows:
NOTE:
Reel components not shown in illustration for
improved clarity.
1. Remove cotter pin (A) and clevis pin (B).
2. Push the reel back until the cylinder barrel (C) lines up
with the aft holes in bracket (D).
3. Reinstall clevis pin (B) at the new position and secure
with cotter pin (A).
Figure 3.99: Forward Position – Center Arm
Figure 3.100: Aft Position – Center Arm
147831
88
Revision A
Summary of Contents for FlexDraper FD1 Series
