MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 309 / 510

HEADER ATTACHMENT/DETACHMENT
3. Start engine, and lower the combine feeder house so
that fl oat module arms (A) are aligned with header
balance channels (B).
4. Drive slowly forward, maintaining alignment
between fl oat module arms (A) and header balance
channels (B).
5. Keep fl oat module arms (A) just under the balance
channels (B) to ensure fl oat module legs seat properly
in the header linkage supports at (C).
IMPORTANT:
Keep hydraulic hoses clear to prevent damage
when driving into header.
6. Continue forward until fl oat module arms (A) contact
stops in balance channels (B) in Figure
4.154: Float
Module Underside, page 291
.
Figure 4.154: Float Module Underside
7. Adjust the length of the center-link (A) using the header
angle hydraulics to approximately align the center-link
eye (B) with the hole in the header bracket.
8. Shut down the engine and remove the key from
the ignition.
Figure 4.155: Center-Link
9. Connect the center-link as follows:
a. Pull pin (B) part way out of the bracket, and remove
the prop from under the center-link (A).
b. Install the pin (B) through the center-link (A)
bracket, and secure with lynch pin.
Figure 4.156: Center-Link
147831
291
Revision A