MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 305 / 510

HEADER ATTACHMENT/DETACHMENT
8. Remove bolt (A).
9. Remove the 9/16 in. nut from bolt (B).
10. Use a 15/16 in. (24 mm) wrench on hex bolt (C) to
rotate latch downwards and slightly raise the feed deck
to remove bolt (B).
11. Rotate the latch (C) up and back to lower the fl oat
module deck and disengage the transition pan tube.
12. Reinstall bolt (A).
13. Repeat for opposite side of the feed draper deck.
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
14. Disengage the reel safety props, start the engine, lower
the reel, and fully raise the header.
15. Stop the engine, remove the key from the ignition, and
engage the combine lift safety props.
Figure 4.143: Float Module Latch
16. Loosen nut and bolt (A), and disengage hook (B) from
leg on both sides of fl oat module.
Figure 4.144: Float Module Underside
17. Rotate hook (B) 90° for storage, and retighten bolt (A)
and nut.
Figure 4.145: Float Module Underside
147831
287
Revision A