19. Remove screw (A) and remove nut and bolt (B) from
both sides of the opening to allow the attachment of
the
fl
oat module deck.
20. Rotate the latch (C) forward and down to engage the
transition pan tube.
Figure 4.160: Float Module Latch
21. Use a 15/16 in. (24 mm) wrench on hex bolt (C) to
rotate latch downwards and slightly raise the feed deck.
Install nut and bolt (B) to lock the latch position.
22. Install screw (A).
23. Repeat for the opposite side of the feed draper deck.
Figure 4.161: Float Module Latch
24. Install
fi
llers (B) on the transition pan support angle (C)
using two bolts (A).
Figure 4.162: Fillers
147831
293
Revision A
Summary of Contents for FlexDraper FD1 Series
