MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 355 / 510

MAINTENANCE AND SERVICING
10. Remove the two bolts and nuts (A), and separate the
drum support arm from the casting.
NOTE:
You may need a second person to lift or support the
drum to remove the bolts
NOTE:
The bolts on the left side of the drum are longer than
the bolts on the right side.
Figure 5.56: Auger Support Arm
11. Place a wooden block under the drive end of the
auger (B) to prevent the auger from dropping and
damaging the feed draper.
12. Use a pry bar (A) to slide the drum assembly to the right
side of the FM100 until the drive sprocket slides off the
end of the spline shaft.
Figure 5.57: Auger Drive
13. Maneuver the drum assembly (A) sideways and
forward so that the endless chain (B) can be removed.
Figure 5.58: Auger Drive
147831
337
Revision A