2. Check that
fl
oat lock linkage is on down stops
(washer [A] cannot be moved) at both locations.
NOTE:
If the header is not on down stops during the
next two steps, the voltage may go out of range
during operation causing a malfunction of the
AHHC system.
Figure 3.305: Float Lock
3. Adjust the cable take-up bracket (B) (if necessary) until
the pointer (A) on the
fl
oat indicator is on the 0.
Figure 3.306: Float Indicator box
147831
192
Revision A
Summary of Contents for FlexDraper FD1 Series
