MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 199 / 510

OPERATION
3.8.11 New Holland Combines
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
3.8.12 New Holland Combines
(CR Series—Model Year 2015 and Later), page 191
.
Checking Voltage Range from the Combine Cab (New Holland)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Position the header 6 in. (150 mm) above the ground, and unlock the fl oat module fl oat.
2. Check that fl oat lock linkage is on down stops
(washer [A] cannot be moved) at both locations.
NOTE:
If the header is not on down stops during the
next two steps, the voltage may go out of range
during operation causing a malfunction of the
AHHC system.
Figure 3.284: Float Lock
147831
181
Revision A